Instructions For The Installer; Installing The Appliance; Transportation, Unpacking; Cleaning - Electrolux AEG S60240DT2 Mode D'emploi

Installing the appliance

Transportation, unpacking

It is recommended to deliver the appliance in origi-
nal packaging, in vertical position considering the
protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape, which ensure the parts not to
move in the appliance.
Wash the inside of the appliance using lukewarm water and
mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy con-
sumption and proper operation of the appliance. When
placing, take into consideration that it is practi- cal to
operate the appliance between ambient tem- perature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST

Instructions for the Installer

Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor, break-
down in the automatic defrosting increasing temperature
in the cooling compartment or increasing energy consump-
tion.
When placing the appliance ensure that it stands level. This
can be achieved by two adjustable feet (1) at the bottom
in front.
GB
25