Remote Control - FireWare Vesta Mode D'emploi Utilisateurs

User Manual
EN
FireWare Vesta

Remote control

1
EMERGENCY STOP
2
ON/OFF
3
EXTRA GAS OUTLET
1. To activate the flame, ignition is required. This is achieved with the ON/OFF button. The
flame continues burning as long as you keep this button pushed down.
Take note: If the flame doesn't ignite after 5 seconds, LET GO of the button. It may be
because it is too windy. Try again in a different location or contact FireWare.
2. You activate the extra module with two buttons. You regulate the gas supply with the
EXTRA button. You ignite the flame with the ON/OFF button. After ignition, you can let
go of the ON/OFF button. As long as you leave the EXTRA GAS OUTLET button pushed
in, the flame will continue burning. The flame goes out when you also let go of the EXTRA
GAS OUTLET button.
Take note: Only use the EXTRA GAS OUTLET button for the extra module and in
combination with the ON/OFF button. With incorrect use, gas can escape that doesn't
ignite. This may cause hazardous situations.
In case of an emergency, push in the EMERGENCY STOP. This stops the flow of all gas and
no ignition will be possible.
If the FireWare Vesta is not in use or left unattended, you must close the gas cylinder and
activate the emergency stop.
22
FireWare Vesta
1
2
3
www.FireWare.nl