FireWare Vesta Mode D'emploi Utilisateurs page 16

User Manual
EN
FireWare Vesta
Place the appliance stabile on a flat surface and make sure the appliance cannot
fall over.
Always place the appliance in an easily accessible location, so that the appliance can be
turned off 'quickly and easily' without running the risk of the appliance falling over.
For a longer life expectancy of the battery, leave it on the charger when the fire extinguish-
er trainer is not in use.
Only use propane or butane as fuel for the fire extinguisher trainer.
Place the gas cylinder at a distance of at least 4 meters from the fire extinguisher trainer.
Make sure gas cylinders always stand firmly upright and cannot fall over.
If a gas cylinder is exchanged, always close the valve on the gas cylinder.
NEVER cover the gas outlet opening at the top of the fire extinguisher trainer completely.
This may cause irreparable damage.
Only use the EXTRA GAS OUTLET button for the extra module and in combination with the
ON/OFF button.
Use the extra gas outlet ONLY for extra modules.
NEVER connect the fire extinguisher trainer directly on the gas cylinder, always position the
operating handle in-between.
Take note of the date printed on the gas hose. This date is the maximum use by date; the
hose must be replaced before this date is reached.
DO NOT touch the appliance during and after use. It may become HOT.
Make sure all people are located on the same side of the equipment as the wind is blowing
from.
Never let the fire extinguisher trainer continue burning for longer than 3 minutes. Then al-
low the device to first cool down for some time before you ignite it again.
Always allow the fire extinguisher trainer to cool down for at least 20 minutes before you
relocate it or place it back in its crate.
NEVER use extra fuels, such as oil of grease.
Keep flammable materials or surfaces at a minimum distance of 5 meters.
Always keep an extra fire extinguisher at hand.
16
FireWare Vesta www.FireWare.nl