Sony TRINITRON KV-25XSD Notice D'emploi page 4

To operate the Commander, point it towards the remote
control detector.
mute button
0,..., 9, 1—,2—buttons
To tune in to:
programme 15, press 1—and 5
programme 25, press 2—and 5
AIB button
Press to select the language in a bilingual broadcast, or to
select the channel in AV mode.
O , +/— analog select buttons
press first, then press
CD(contrast) will appear on the screen. Adjust by pressing
+ or -. Press @ again and adjust
ness), (bass), (treble) and balance.
reset button
Press to reset colour and contrast to factory-set levels.
d) standby button
Press to change to the standby mode. use this button to
turn off the set for short periods of time.
To turn on the set, press TV or the programme number;
there will be a slight delay before the picture is restored.
TV button
Press to change to the TV mode from the standby,
input or teletext modes.
4
AIB
andör
(colour), CT (bright-
TV
PROGR
Buttons used
VTR operation
Other buttons are used for teletext operation.
(See next page.)
@ input button
Pressto view the input picturecoming in through the é-
connector.
"G-" lights up on the screen.
Press IV or the programme number to return to the TV
v loudness button
Press to emphasize high and low notes.
on-screen display button
Press to make the display appear on the screen.
Press again to make it disappear.
5 space sound button
Press to obtain special acoustic effects.
PROGR programme scan buttons
volume buttons
for