Panasonic RP-HC100 Manuel D'utilisation page 2

Precautions
Listening caution
Do not play your headphones at a high volume.
Hearing experts advise against continuous extend-
ed play.
If you experience a ringing in your ears, reduce
volume or discontinue use.
Do not use while operating a motorized vehicle. It
may create a traffic hazard and is illegal in many
areas.
You should use extreme caution or temporarily
discontinue use in potentially hazardous situa-
tions.
Sound can be deceiving. Over time your hearing
"comfort level" adapts to higher volumes of sound.
So what sounds "normal" can actually be loud and
harmful to your hearing.
Guard against this by setting your equipment at a
safe level BEFORE your hearing adapts.
To establish a safe level:
•Start your volume control at a low setting.
•Slowly increase the sound until you can hear it
comfortably and clearly, and without distortion.
Once you have established a comfortable sound
level:
•set the dial and leave it there.
The serial number of this product can be found
on the label under the right ear pad.
Please note them in the space provided below
and keep as a permanent record of your pur-
chase to aid identification in the event of theft.
MODE L NUMBE R RP-HCI 00
SERIAL NUMBER
Notes on use
The battery is used by the noise cancelling func-
tion and, even without it, the unit functions
normal pair of headphones.
This noise cancelling function mainly reduces IQW
frequency sounds below 1500 Hz. For this reason,
sounds with higher frequency portions remain rela-
tively intact.
The noise cancelling function acts to make a qui-
eter listening environment in places with a lot of
noise. Turn the function off when listening
places that are already quiet,
Noise may occur due to dirt on the plug. Clean the
plug with a soft dry cloth if this occurs.
Product Service
Do not attempt to remove the cover(s) or repair
the unit yourself. 'Refer servicing to qualified per-
sonnel only.
For product service, product information or assis-
tance with product operation, refer to the servicen-
ter directory.
User memo:
DATE OF PURCHASE
DEALER NAME
DEALER ADDRESS
TELEPHONE NUMBER
as a
2 3
in
1 2
Specifications
Type:
Dynamic, close-type
Driver units: 36 mm (17/16in.) diameter
Impedance: 35 Ohms at I kHz (when OPR is on)
55 Ohms at 1 kHz (when OPR is off)
Sensitivity: 100 dB/mW (when OPR is on)
102 dB/mW (when OPR is off)
Frequency response:
Frequency range of active noise reduction:
40—1 ,500 Hz, more than
Power handling capacity:
Power requirement:
(R03/LR03, AAA, UM-4 dry cell batteryx 1)
Using the headphones
1. Turn down
equipment
plug [3.5 mm (1/8 in.) stereo
the headphone
2. Check the sides (L and R), then put
them on. Move
down to suit the housing
your ears.
Start play on the audio unit and adjust
3.
the volume.
If noise cancelling
4.
the OPR switch,
side housing,
The OPR lamp lights up.
5. Move the OPR switch
tion if noise cancelling is not required.
The OPR lamp goes out.
The unit acts like norma' headphones
case.
How to fold
headphones
1. Slide the headband
possible.
2. Push the two sides together
YlülV
Battery life:
Approx. 50 hours (LR03 alkaline battery)
Cord:
Plug: Stereo mini•plug [3.5 mm (h in.) diameter),
8-22,000 Hz Weight:
Approx. 145 g (5.12 oz.) (without cord and battery)
Approx. 175 (6, 18 oz.) (with cord and battery)
10 dB at 300 Hz
1 .OOO mw
DC 1.5 V
@
the volume on the audio
and insert the headphone
mini] into
jack.
the sliders up and
position to
is required, move
located on the right
to the ON position.
to the OFF posi-
in this
the
E
down as far as
and up.
Approx. 25 hours
(R03 manganese battery)
Approx. 1.5 m (4.9 ft.) long
L-type, gold plated