Seko KRONOS 50 Manuel D'installation page 15

Paragraph 7
Programming
Density
1.00 kg/L
Paragraph 8
Programming
Triggers
No Trg
Paragraph 9
Programming
Units
L/h
Paragraph 10
Programming
Buzzer
Off
Paragraph 11
Programming
Level Alarm
Stop
0000137630
This makes it possible to set the density of the chemical
product.
This makes it possible to set the input triggers.
When the triggers are present, gives consent to the pump
to run, depending the setting pump function:
No Trg= the triggers are disabled.
•
Trg 1= the pump run when only the trigger 1 is
•
enabled.
Trg 2= the pump run when only the trigger 2 is
•
enabled.
Trg 1&2= the pump run when the both triggers
•
(1&2) are enabled.
This makes it possible to set unit of measurement, which
can be:
L/h= liter per hour.
•
• ml/m= milliliter per minute.
Gph= Gallon per hour.
•
• %= the percentage of the maximum flow-rate.
The buzzer is active when there is an alarm condition.
This makes it possible to set the buzzer the system to On
or Off.
This makes it possible to set the level alarm as follow:
Stop= the pump stops.
•
Run= the pump keeps running.
•
Rev. 4.2
Operation
Operation
Operation
Operation
Operation
13