Technical Data; Operating Elements And Connections; Transformer Operation With Wired Gong Module - Duwi gong de base Ritmo Mode D'emploi

GB
cONteNts
. Intended use
2. Technical data
3. Operating elements and connections
4. Opening the gong
5. Transformer operation with wired gong module
6. Battery operation with wired gong module
7. Battery operation with radio module
8. Melody selection with wired gong module
9. Melody selection with radio module
0. Adjusting the volume
. Operation with sound module
2. Operation with USB-module
3. Help
4. Cleaning
5. Warranty
6. Battery disposal
7. Illustrations
8. Additional Accessories
Dear customer,
Thank you for buying our high quality, expandable gong Ritmo. Please read the following operating instructions through carefully before
starting the gong.
1. INteNDeD use
The gong is only designed to be used with the appropriate batteries or with an 8V transformer (only when operating with a wired gong
module). Never connect it to other voltages.

2. techNIcAl DAtA

Dimensions:
Voltage:
Operating temperature:
Batteries:
Operating frequency of radio module:
Loudness:
The gong conforms to the applicable European CE guidelines.

3. OpeRAtING eleMeNts AND cONNectIONs

Fig. 
() Volume controller (VOL)
(2) Module slot for wired gong module or radio module
(3) Expansion slot for sound module or USB-module
(4) Battery compartment for .5 V battery (LR4 Baby)
(5) Connections for bell wiring
(6) „SEL"-selector for melody selection at T3
(7) Slide switch: „SEQ" - for changing melody at T3;
„SET" – to use a selected melody at T3
(8) Rotary switch to select the house code
4. OpeNING the GONG
To open the gong, release the cover from the base (Fig. 2), if necessary use suitable work tools (e.g. screwdriver) to push in the latches
of the cover.

5. tRANsFORMeR OpeRAtION wIth wIReD GONG MODule

Numerous multi-storey apartments have a central bell plate at the entrance to the building with pre-installed alternating current wiring
to every apartment. Remove the cover from the gong and insert 4 x .5 V-batteries in – take care to ensure they are inserted with the
correct polarity.
Connecting the incoming bell lines with T and T4 produces a three-tone sound when the entrance bell is pressed. Connecting the inco-
ming bell lines to T3 and T4 produces a polyphone melody when the entrance bell is pressed (refer to point 8 for melody selection).
A second bell can be installed at your apartment door for example at the same time. Insert 4 x .5 V-batteries – take care to ensure the
polarity is correct.
building bell plate
20 x 75 x 50 mm
8-2V AC
0°C - 40° C
4 x .5 V LR4 Baby (not included)
433,92 MHz
max. 80dB/A
9