Battery Operation With Wired Gong Module - Duwi gong de base Ritmo Mode D'emploi

GB
Connecting the incoming bell lines with T and T4 produces a three-tone sound when the other bell is pressed. Connecting the incoming
bell lines to T3 and T4 produces a polyphone melody when the other bell is pressed (refer to point 8 for melody selection).
Please observe that it is recommended to only use bell plates that have no illumination, since the light would lead to the batteries running
out very quickly. These varying connection possibilities enable you to distinguish calls between two bells, between for example the bell
ring of the entrance door and that of the apartment door.
Example

6. BAtteRy OpeRAtION wIth wIReD GONG MODule

Remove the cover of the gong and insert 4 x .5 V batteries – take care to ensure the polarity is correct. Connecting the bell wires with
the connections T and T4 produces a three-tone sound when the bell is pressed. Connecting the bell wires with the connections T3 and
T4 produces a polyphone melody when the bell is pressed (refer to point 8 for melody selection).
Please observe that it is recommended to only use bell plates that have no illumination, since the light would lead to the batteries running
out very quickly. These varying connection possibilities enable you to distinguish calls between two bells, e.g. between for example the
bell ring of the entrance door and that of the apartment door.
7. BAtteRy OpeRAtION wIth RADIO MODule (NOt INcluDeD)
Remove the cover of the gong. Loosen the screws of the wired gong module and remove it from the module slot. Insert a radio module
(available with a range of 50m/00m/200m) and attach it with the existing screws.
Insert the 4 x .5 V batteries into the gong and 2 x .5 V AAA micro batteries into the transmitter (not included) – take care to ensure
the polarity is correct.
Match the house code of the gong and the transmitter, i.e. both rotary switches should point to the same number.
This product would not perform normally under a strong electro static environment, it may need manual reset to normal operation.
building bell plate
Receiver Transmitter
0