Switching The Appliance On; Finishing Work; Cleaning And Care - Salvis Master Mode D'emploi

en
2.4

Switching the appliance on

3.

Finishing work

. Turn rotary switch to the 0 position.
D The indicator light or the illuminated ring goes out.
. Clean the appliance, see the 4. "Cleaning and care" section below.
. Turn off the mains switch.
4.

Cleaning and care

Notes
D Do not apply any caustic cleaners to the control panel or rotary switches.
D Do not spray off or clean the appliance with water hoses, high-pressure cleaners, high-pres­
sure steam cleaners or general steam cleaners.
D Follow the instructions supplied by the manufacturer of the cleaning product.
D Do not use any scouring cleaning product or damaged cleaning scrapers. These cause
scratches.
D Do not clean the ceramic surface with grill cleaners.
D Stainless steel must not be in prolonged contact with concentrated acids, vinegar essence,
salt solution, mustard or spice mixtures, otherwise the protective coating will be corroded.
Rinse stainless steel surfaces clean and rub them dry after use.
Cleaning and maintenance products
Suitable cleaning and maintenance products can be obtained from your customer service.
These include e.g.:
− grease-dissolving cleaning products or special stainless steel cleaners,
− protective stainless steel cleaners,
− cleaning products and cleaning scrapers for ceramic surfaces.
22 / 60
Rotary switch types
Indicator
light
Illuminated ring
. Place a pan or pot on the ceramic surface or
in the bowl.
. Turn the rotary switch to the desired power
setting.
D Setting and temperature range 1 - 9:
1 = low power, 9 = high power.
D The indicator lamp or the illuminated ring will
light up.
D The indicator light or the illuminated ring
flashes if no cookware has been placed on
the hob but the appliance is switched on.
D Pots and pans with a diameter less than
approximately 12 cm are not recognised and
will therefore not be heated. The indicator
lamp or the illuminated ring will flash.
. After removing the pot or pan, turn the
rotary switch to "0".