Cleaning Accessories; Cleaning The Hob; Cleaning The Control Panel; Cleaning The Inside Of The Oven (Cooking Area) - Whirlpool W5V8Lcsa Manuel D'utilisation

Glass surfaces
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry
it with a dry microfiber cloth.
• If there is residual detergent after clean-
ing, wipe it with cold water and dry with a
clean and dry microfiber cloth. Residual
detergent may damage the glass surface
next time.
• Under no circumstances should the
dried-up residue on the glass surface be
cleaned off with serrated knives, wire
wool or similar scratching tools.
• You can remove the calcium stains (yel-
low stains) on the glass surface with the
commercially available descaling agent,
with a descaling agent such as vinegar or
lemon juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a sponge
and wait a long time for it to work prop-
erly. Then clean the glass surface with a
wet cloth.
• Discolorations and stains on the glass
surface are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm wa-
ter and a soft cloth or sponge and dry
them with a dry cloth.
• Ensure that the joints of the components
of the product are not left damp and with
detergent. Otherwise, corrosion may oc-
cur on these joints.
9.2

Cleaning Accessories

Refrain from putting the product accessor-
ies in a dishwasher unless otherwise stated
in the user's manual.
9.3

Cleaning the hob

Glass cooking surface
Follow the cleaning steps described for the
glass surfaces in the "General cleaning in-
formation" section for the cleaning of glass
cooking surface. You may complete your
cleaning as per the information below for
special cases.
• Sugar-based foods such as dark cream,
starch and syrup should be cleaned im-
mediately, without waiting for the surface
to cool. Otherwise, the glass cooking sur-
face may be permanently damaged.
9.4

Cleaning the Control Panel

• When cleaning the panels with knob-con-
trol, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Refrain from removing the knobs and
gaskets underneath to clean the panel.
The control panel and knobs may be
damaged.
• While cleaning the inox panels with knob
control, Refrain from using inox cleaning
agents around the knob. The indicators
around the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth.
If your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
9.5 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" section ac-
cording to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls. It
varies by model. If there is a catalytic wall,
refer to the "Catalytic surfaces" section for
information.
If your product is a wire shelf model, re-
move the wire shelves before cleaning the
side walls. Then complete the cleaning as
described in the "General Cleaning Informa-
tion" section according to the side wall sur-
face type.
To remove the side wire shelves:
1. Remove the front of the wire shelf by
pulling it on the side wall in the opposite
direction.
2. Pull the wire shelf towards you to re-
move it completely.
EN / 31
EN
FR