Zoom Mode; Sequential Mode; Recorder View - Abus TVAC21000 Manuel Utilisateur

By pressing the [ENTER] key you can change the way pictures are arranged using [-] and [+] (right and
left) and [↑] and [↓] (up and down). When you have positioned the pictures, press [MODE] again to
confirm.
To quit PIP/POP mode, either press one of the camera keys (1–4) or the [QUAD] key.

7.3 Zoom mode

If you press and hold the [ZOOM] key, a rectangular frame appears on the screen. Press [ENTER] to
zoom into this area. You can control it using the channel keys [↑], [↓] and "+", "-". Press again to zoom back
to the previous view with the frame.
Press and hold the [ZOOM] key to quit zoom mode.

7.4 Sequential mode

Press and hold the [AUTO] key to start sequencing mode. The device switches automatically to the
respective camera or to QUAD mode. You can set the switching time for the sequence in the programming
menu under AUTOSEQ SETUP (p. 15).
Sequential mode will only work if at least one camera is connected. The sequence time
must be at least 1 second.
To exit sequential mode, press one of the channel keys or the QUAD key. The function of the key you
press will be executed.
(e.g.: you press the channel key "1" to exit. Sequential mode is interrupted and the picture from camera 1
is shown on the screen.)

7.5 Recorder view

Connect the monitor output of the recorder to the "VCR-IN" input of the QUAD. Press and hold the [VCR]
key to go to the recorder view. The letters "VCR" appear in the top right corner of the monitor.
The screen setting of the recorder is then display, for example the 16x camera view of a 16-channel
recorder (fig. 1).
1 2
5 6
9 10
13 14
Fig. 1
28
3 4
7 8
11 12
15 16
English