DeWalt DXGP210 Manuel De L'utilisateur page 43

PROBLEM
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days) and/or improperly
mixed
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days) and/or improperly
mixed
The air filter is dirty
The spark plug is fouled
THE GUIDE BAR AND SAW CHAIN ARE RUNNING HOT, SMOKING OR STUCK
The saw chain tension is too tight
The chain oil reservoir is empty
THE SAW CHAIN DOES NOT ROTATE
The saw chain tension is too tight
The guide bar and saw chain are assembled
incorrectly
The guide bar and saw chain are damaged
The drive assembly is damaged
THE SAW CHAIN ROTATES, BUT DOES NOT CUT
The saw chain is dull
The saw chain is on backwards
If further assistance is required, contact an authorized service center.
SOLUTION
Drain the fuel tank and add fresh, properly-
mixed fuel
Clean or replace the air filter
Drain the fuel tank and add fresh, properly-
mixed fuel
Clean or replace the air filter
Replace the spark plug
Adjust the saw chain tension
Refill the chain oil reservoir
Adjust the saw chain tension
Refer to Installing / Replacing the Saw Chain
Inspect the guide bar and saw chain for damage.
Replace them if necessary
Refer to Service information
Replace the saw chain or have it sharpened by an
authorized service dealer
Check and correct the saw chain direction
43