DeWalt DXGP210 Manuel De L'utilisateur page 22

ASSEMBLING AND USING THE SHOULDER STRAP
Assembling the Shoulder Strap
1. Push the strap up through the center slot in the buckle (Fig. 6).
2. Bend the strap over and push it down through the lower slot in the buckle (Fig. 6).
Using the Shoulder Strap
1. Put the shoulder strap over the operator's head and onto the left shoulder (Fig. 8).
2. Start the unit. Refer to Starting and Stopping.
3. Snap the clip onto the shoulder strap / harness loop (Fig. 7).
4. Adjust the shoulder strap to fit the operator (Fig. 9). Pull the buckle up to loosen the shoulder strap.
Pull the strap down to tighten the shoulder strap.
Buckle
Center Slot
Clip
Lower Slot
Strap
Fig. 6
Clip
Shoulder Strap / Harness Loop
Fig. 7
22