Maintenance; Removal/Installation - Terrier TSCC Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- Clean the object where the lifting clamp will be fitted, removing, grease, dirt and mill
scale.
- Open the clamp by means of the spindle Position the jaw fully on the object and make
sure the clamp is attached in such a way that the load is balanced during hoisting.
- Secure the clamp by completely tightening the spindle.
Use at least 40 Nm for the 1.0 TSCC t/m 6.0 TSCC and at least 10 Nm for the 0.5 TSCC.
This force can possibly be increased further when hoisting heavier or thicker materi-
als. Remove the handle of the screwspindle after attaching the clamp.
- Hoist steadily to allow effective gripping on taking up the load.
- If the load slips, work through the "hoisting" section (5) again.
- Make sure the load is stably positioned before the clamp is removed from the object.
6

MAINTENANCE

- Check the general condition of the clamp at least once monthly, see the
"removal/installation" section (7).
- Do not use the clamp if:
- the housing is damaged or deformed, especially the corners of the jaw,
- the fastening is visibly deformed,
- the pivot is stretched or broken,
- the spindle mechanism, no longer works (properly),
- the split pin is missing.
- the marking on the clamp is no longer legible.
Depending on the extent of damage discovered:
- remove and clean the clamp (see "removal/installation" section (7)) or
- have the clamp revised by Terrier Lifting Clamps B.V. or another authorised revision
company (see "revision" chapter (8)).
If in doubt, contact your supplier.
7

REMOVAL/INSTALLATION

- Open the clamp completely.
- Carefully remove the spindle from the housing. (1)
- The cam can now be removed from the spindle (2)
- Remove the securing device. (3)
- Remove the pivot by removing the nut
and bolt (6 & 7)
- Clean all parts using a standard degreasing
agent.
- Grease the spindle and the inside of the cam.
- Put everything back in the reverse order.
- Always install new, original split pins.
- When replacing parts,
always use original Terrier parts.
- Remove any burrs with a file.
If in doubt, contact your supplier.
11

Publicité

Table des Matières
loading

Table des Matières