FEIG Electronic MWD BPC-H Mode D'emploi page 43

MWD BPC-H / MWD BPC-HU
[Unit]
P.
Range
L.662
L.762
L.862
L.962
L.664
L.764
L.864
L.964
L.66A 0 ... 1
L.76A
L.86A
L.96A
L.66B 0 ... 1
L.76B
L.86B
L.96B
7.1.1 Motion detector, channel 1
Table 8: Motion detector, channel 1
P. [Unit]
Range
L.620 1 ... F
L.720
L.820
L.920
L.621 0 ... 2
L.721
L.821
L.921
FEIG ELECTRONIC GmbH
List of the service parameters
Function
Software version This Parameter shows the software version of Motion
Motion detector detector.
Hardware version of This Parameter shows the Hardware version of Motion
Motion detector detector.
Behaviour in case of This parameter is used to configure the behaviour of the
error Motion detector control input to which channel 1 of the motion detector is
connected when it detects an error in the motion detector.
Behaviour in case of This parameter is used to configure the behaviour of the
error Motion detector control input to which channel 2 of the motion detector is
connected when it detects an error in the motion detector.
Function
Sensitivity This parameter defines the sensitivity for the channel to be
parameterized.
Direction detection This parameter specifies wether the motion detector reacts
to approaching or departing objects.
If the vehicle or human filter is activated, only
directional detection direction is permitted. Changes to
the setting "detection direction" will be blocked.
43/74
Description/ Note
0: Input is actived
1: Input remains inactive
0: Input is actived
1: Input remains inactive
Description/ Note
1: low ... F: high
0: deactivated
1: approaching
2: departing
MWD_BPC-H-HU_ver4_Manual_rev0_mul
EN