Initial Operation; Suspending The Tool; Compressed-Air Connection - Orgapack OR-H 20 A Mode D'emploi Et De Sécurité

ORGAPACK OR-H 20 A
5

5.1 SUSPENDING THE TOOL

The tool can be suspended on a spring balancer with
the suspension bracket (3/1) supplied. The suspension
bracket is designed to operate the tool horizontally or
vertically.
Optionally a suspension bracket is available to operate
the tool also sideways.

5.2 COMPRESSED-AIR CONNECTION

Motor and sealing piston are lubricated by oil mist of
the compressed air. Properly prepared compressed air
is therefore essential for troublefree operation of the
tool. This can only be ensured by a reliably functioning
maintenance unit, consisting of water separator,
pressure reducing valve with pressure gauge and oil
mist lubricator.
The air pressure at the pressure reducing valve should
be set at 5–6 bar. The oil mist lubricator should supply
sufficient oil.
The length of the hose between the OR-H 20 A tool
and the maintenance unit should not exceed 5 m
(15 ft). The internal diameter of the pipe should be at
least 10 mm ( 3 / "). It must be ensured that the hose
8
does not form loops, where oil can collect.
22

INITIAL OPERATION

Horizontally
Vertically
Fig. 3
1
08.03/WE