Using The Timer - Buffalo Cu607 Mode D'emploi

Adjusting Top Plate Tension
Note: If top plate becomes loose/ stiff use the Allen key supplied to adjust the
tension.
BUFFALO recommend the appliance is disconnected from the power supply and
allowed to cool before any adjustments are made.
1. Remove the rubber stoppers on the top of the rear cover.
2. Use the Allen key supplied to adjust the tension of the top plate. Turn clockwise to tighten,
anti-clockwise to loosen.
3. Re-locate the rubber stoppers in place.

Using the timer

The digital timer with audible alarm can be set from 1 second to 15 minutes. The timer provides an
audible alarm after the set time expires. It provides no electrical control over the unit.
START/STOP: Press START/STOP to start timer, press again
•
to stop. The timer will provide an audible alarm after the
set time. The alarm will beep 10 times and the display will
continue to flash until timer is reset (press the START/STOP
button).
• UP: Press UP to add extra time.
DOWN: Press DOWN to reduce time.
•
PROGRAM: There are a total of 6 programmable timer settings. The default factory program settings
•
are given below.
Program
Factory preset time
• To change the length of a program select the program you want to change by scrolling using the
PROGRAM button.
• Adjust the program time by using the UP and DOWN buttons. Press START/STOP to commence the
count-down. The new program time will be automatically stored.
• If the unit is left without power for more than 24hrs the timer settings will revert to the factory
defaults.
CU607-CU613_ML_A5_v2_20250728.indb 5 CU607-CU613_ML_A5_v2_20250728.indb 5
1 2 3 4
01:00 02:00 03:00 05:00 10:00 15:00
EN
5 6
5
2025/7/28 11:28 2025/7/28 11:28