53 Reproduction Via Audio In; Reset; 62 Reset To Factory Settings - Monacor IWA-50WIFI⁄WS Mode D'emploi

5.3 Reproduction via AUDIO IN
1) Use a cable with a 3 .5 mm plug to con-
nect an analog audio source (e . g . line level
output or headphone output of a mobile
audio device, computer or mixer) to the
jack AUDIO IN (1) . As soon as the plug is
connected to the jack, the amplifier will
switch to this jack and the LED indicator
(5) will light in red . Any existing Bluetooth
connection will be interrupted .
It is also possible to use the menu item
"Input Mode" of the software "AllPlay
Jukebox" to select the input AUDIO IN as
a signal source .
2) Use the buttons −/+ (8) or the software
"AllPlay Jukebox" to adjust the volume .
The LED indicator will flicker while the
volume is being adjusted .
3) Use the button
mute the sound . The LED indicator will
flash slowly while the sound is muted .
4) When you disconnect the 3 .5 mm plug,
the amplifier will automatically go to the
network mode . The red LED indicator will
go out and the Wi-Fi LED indicator (3) will
light instead . The amplifier will also go to
the network mode when the replay of
an audio file is started by means of the
software "AllPlay Jukebox", for example .
Note: When an audio source is not used any more,
disconnect it from the jack AUDIO IN; otherwise,
annoying noise may occur .
5.3.1 Forwarding audio signals to the
network
The audio signal of an audio source cannot
only be reproduced at the amplifier to which
the source is connected via the jack AUDIO
IN, it can also be forwarded to other ampli-
fiers IWA-50WIFI / WS in the same network .
22
(9) to mute and un-
Notes:
– A 5 GHz multimedia router is recommend for this
function .
– High data traffic in the network (e . g . due to video
streaming, file download) can impair transmission
quality .
– When a group of output units has been created
in the software "AllPlay Jukebox", the signals will
be automatically forwarded to the entire group . To
forward the signals to a different group of output
units, create a new group (multiroom mode) be-
fore you select the input AUDIO IN as the source .
– When you press the button
to which the audio source is connected, the entire
group will be muted .

6 Reset

The amplifier IWA-50WIFI / WS provides the
following reset options .
6.1 Restart
The amplifier name and the network settings
will be retained . To restart the amplifier, press
the buttons −, + (8) and
time .
All three LED indicators (3 – 5) will flash
slowly until the amplifier is connected to the
network . The LED indicator (3) will light in
white once the connection has been estab-
lished .
6.2 Reset to factory settings
When the amplifier is reset to its factory
settings, the network connection must be
re-established . For a reset, keep the button
(2) pressed for 8 seconds .
After 40 seconds, only the LED indicator
(3) will light in white; the amplifier is ready
for re-connection to the network (
ter 4 .7) .
(9) at the amplifier
(9) at the same
☞
chap-