Creating A Group; 52 Replay Via Bluetooth; 521 Forwarding Audio Signals To The Network - Monacor IWA-50WIFI⁄WS Mode D'emploi

5.1.1.1 Creating a group

1) In the software "AllPlay Jukebox", call up
the view "Select a Player" .
2) Tap "Group" for one of the desired group
members .
3) From the list, select the output units you
want to include in the group .
4) Tap "done" to confirm your selection .
Music will be replayed via all output units
included in the group .
5.2 Replay via Bluetooth
The amplifier IWA-50WIFI/WS is able to re-
ceive audio signals via Bluetooth (e . g . from
a smartphone or tablet PC) if these devices
support the Bluetooth profiles A2DP/AVRCP .
The reception range is 10 m .
1) Activate the Bluetooth function at the
Bluetooth audio source (
the Bluetooth audio source) .
2) Keep the button
onds: The LED indicator (4) starts flashing
rapidly in blue .
3) As long as the LED indicator keeps flash-
ing, select the amplifier from the list of
available Bluetooth devices at the Blue-
tooth audio source and pair* the ampli-
fier . The amplifier will be listed with the
name it has been assigned for network
operation . When the devices have been
paired, they will be connected automat-
ically . When the connection has been
established, the LED indicator will light in
blue permanently .
If the Bluetooth connection has not been
established after 1 minute, the amplifier
will go back to the network mode .
*Note: If this is not the first time that the two
devices are connected (and the name of the am-
plifier has not been changed in the meantime),
pairing will be omitted and the connection will
be established immediately .
☞
manual of
(7) pressed for 4 sec-
4) Start the audio replay at the Bluetooth
audio source .
5) The replay volume depends on the setting
at the Bluetooth audio source and on the
setting made by means of the buttons
−/+ (8) .
6) Use the button
mute the sound . The LED indicator will
flash slowly while the amplifier is muted .
7) When the Bluetooth connection is discon-
nected on the part of the Bluetooth audio
source, the LED indicator starts flashing
and the amplifier is ready to be connected
once again . If the connection has not been
re-established after 1 minute, the ampli-
fier will go back to the network mode .
5.2.1 Forwarding audio signals to
the network
The audio signal of a Bluetooth audio source
cannot only be reproduced at the amplifier to
which the source is connected, it can also be
forwarded to other amplifiers IWA-50WIFI / WS
in the same network .
Notes:
– A 5 GHz multimedia router is recommend for this
function .
– High data traffic in the network (e . g . due to video
streaming, file download) can impair transmission
quality .
– When a group of output units has been created
in the software "AllPlay Jukebox", the signals will
be automatically forwarded to the entire group .
To forward signals to a different group of output
units, create a new group (multiroom mode) be-
fore going to the Bluetooth mode .
– When you press the button
connected via Bluetooth, the entire group will be
muted .
(9) to mute and un-
(9) at the amplifier
21