Description And Overall Dimensions; Description; Overall Dimensions; Surrounds - deville C07836 Notice D'installation Et D'emploi

3 - DESCRIPTION AND OVERALL DIMENSIONS

3.1 DESCRIPTION

The main components of your insert are indicated below and identified on Fig. 1.
The Deville turbo-insert is made of 4 mm steel, the inside is covered on the back and on both sides with cast iron
decorated plates. The two cast iron doors, as well as the ash pan door, are fitted with seals which ensure
tightness and allow the appliance to stay in for a very long time. The burning speed is adjusted with the
thermostat.
A two-speed blower allows the circulation of hot air to be activated. The top of the casing includes 4 connections
diam. 125. This equipment allows you to send a hot air flow in 4 different directions (adjacent rooms). If not
connected with hot air ducts, your insert will provide a better convection in the room where it is installed.
The draught damper (pipe key) allows to reduce the excessive depressions of some flue pipes.
Net weight
3.2 OVERALL DIMENSIONS (FIG. 2)
Outside dimensions (mm) :
Overall
4 – SURROUNDS AND OPTIONAL ACCESSORY

4.1 SURROUNDS

Your turbo insert can be installed within either a Deville stone fireplace (choose among our commercial brochure)
or an existing fireplace.

4.2 OPTIONAL ACCESSORY

On request, your insert can be completed with a barbecue kit C07012, for pleasant and cheerful grill-parties (Fig.
3).
5 – CONDITIONS FOR THE INSTALLATION OF THE APPLIANCE
IMPORTANT : TO AVOID ANY FIRE RISK, THIS APPLIANCE MUST BE INSTALLED IN COMPLIANCE WITH
CURRENT RELEVANT SPECIFICATIONS (D.T.U. 24-2-2) AND IN THE RESPECT OF THE PRESENT
INSTRUCTIONS. INSTALLATION MUST BE ACHIEVED BY A QUALIFIED TRADESMAN.
Installation should comply with the basic recommendations given below. However, these cannot under any circumstances
replace strict application of any of the provisions of DTU 24-2-2.
5.1 DEFINITION OF COMPONENTS INCLUDED IN THE SMOKE EVACUATION SYSTEM (FIG. 4)
5.2 CHARACTERISTICS AND SIZE OF THE SMOKE FLUE, TO WHICH THE APPLIANCE MUST BE CONNECTED

5.2.1 Type of Smoke Flue

5.2.1.1 New Smoke Flue
The following materials must be used :
-
C07836
186 kg
Width
772
18
C07867
175 kg
Height
730
C07887
173 kg
Depth
514