Setup Menu List - Yamaha CD-N500 Mode D'emploi

Masquer les pouces Voir aussi pour CD-N500:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
SETUP MENU

Setup menu list

Menu
Submenu
DHCP
IP Address
Subnet Mask
Network
Default
Configuration
Gateway
DNS Server
(P)
DNS Server
(S)
MAC
Address
Network
Information
Status
System ID
Network Standby
Auto Power Down
Dimmer
Firmware Version
Firmware Update
*1: When "DHCP" is "On", you can check the values (IP address, etc.) assigned by the DHCP server.
24
En
Settings
(Bold:
default)
Select "On" to use the DHCP server to automatically configure the
On, Off
network settings of this unit or "Off" to configure manually.
Specify the IP address when "DHCP" is "Off".
Specify the subnet mask when "DHCP" is "Off".
Specify the default gateway when "DHCP" is "Off".
Specify the primary DNS server when "DHCP" is "Off".
Specify the secondary DNS server when "DHCP" is "Off".
The MAC address of this unit is shown. The MAC address is also used
as a vTuner ID.
The network status of this unit is shown ("Connected" or "Not
connected").
The system ID number is shown.
On, Off
Select "On" to enable the network standby mode.
4 Hours,
This unit automatically enters standby mode if it is left turned on for
8 Hours,
the selected time without playback or any other operation being
12 Hours,
performed.
Off
–3 to 0
Adjust the brightness of the front panel display.
The firmware version of this unit is shown.
Update the firmware of this unit after selecting "Network" or "USB".
Network,
When "Press ENTER to start" appears, press ENTER to start firmware
USB
update. Do not operate this unit until "UPDATE SUCCESS" appears.
Then turn off this unit once and turn it on again.
Function
*1
*1
*1
*1
*1

Publicité

Table des Matières

Dépannage

loading

Table des Matières