Dräger PARAT 4000 Série Notice D'utilisation page 16

Use
Dräger PARAT 5510 (Single Pack)
1. Open the packaging (Figure 1 on page 2).
2. Grasp the escape hood and pull it out of the packaging (Figure 2 on page 2).
3. Grasp the pull cords and pull both plugs out of the filter (Figure 3 on page 2).
Dräger PARAT 5550
1. Open the bag.
Grasp the foil pouch and pull it out of the bag (Figure 1 on page 2).
NOTICE
i i
If the foil pouch is severely damaged and moisture visibly entered the
packaging in the form of drops, replace the escape hood.
2. Open the foil pouch at the notch highlighted in colour (Figure 2 on page 2).
3. Grasp the red pull cords at the edge of the foil pouch. 
Grasp the escape hood and pull it out of the foil pouch. Both plugs must be
pulled out of the filter (Figure 3 on page 2).
The following steps are necessary for all variants of the PARAT escape
hoods:
Check that both plugs have been removed. Grasp any plugs that have not

been removed at the clasp and pull them out.
Don the escape hood yourself or fit it on the person to be rescued (Figure 4

on page 2):
Grip the collar with both hands and open it wide.
Pull the escape hood over your head or first insert your chin and then pull the
escape hood over your head as necessary. 
Make sure that your nose and chin are positioned inside the half mask. If
required, take hold of the filter, pull it forward and move the half mask so that
it is positioned correctly over your mouth and nose.
All your hair must be tucked under the escape hood.
.
WARNING
!
Full beards, deep scars and long sideburns can cause leaks and put the
wearer of the device at risk!
If the escape hood is used by children, an adult should make sure that
the half mask is positioned correctly around the chin and nose.
Check the sealing of the face mask: 

close the filter opening with the ball of your hand. If you can feel an airflow,
correct the position of the half mask.
Breathe calmly! 

Breathing is slightly more difficult. The breathing air can become noticeably
warmer, this is an indication that the filter is operating correctly.
16 Dräger PARAT 4000/5000/7000
en