Makita PK5011C Manuel D'instruction page 5

e) Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades create
frequent kickback and loss of control.
Safety Warnings Specific for Grinding Operation:
a) Use only wheel types that are recommended
for your power tool and the specific guard
designed for the selected wheel. Wheels for
which the power tool was not designed cannot be
adequately guarded and are unsafe.
Safety Warnings Specific for Sanding Operations:
a) Do not use excessively oversized abrasive
disc. Follow manufacturers recommendations,
when selecting abrasive disc. Larger abrasive
disc extending beyond the pad presents a
laceration hazard and may cause snagging,
tearing of the disc or kickback.
Additional safety warnings:
16. Always use a sanding disc or offset diamond
wheel specifically designed for wet operation.
17. Always install the dust cover before operation.
18. Ground Fault
protection should be provided on the circuit(s)
or outlet(s)
Receptacles are available having built-in GFCI
protection and may be used for this measure
of safety.
19. For additional protection against electric
shock, be sure to WEAR RUBBER GLOVES
AND RUBBER BOOTS during operation.
20. When using the water feed, be careful not to
let water get into the motor. If water runs into
the motor, an electric shock hazard may
result.
21. PROPER GROUNDING. This tool should be
grounding while in use to protect the operator
from electric shock.
22. EXTENSION CORDS. Use only three-wire
extension cords which have three-prong
grounding-type
receptacles which accept the tool's plug.
Replace or repair damaged or worn cord
immediately.
23. Make sure the abrasive disc is not contacting
the workpiece before the switch is turned on.
24. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
25. Do not leave the tool running. Operate the tool
only when hand-held.
26. Do not touch the workpiece or the offset
diamond wheel immediately after operation; it
may be extremely hot and could burn your
skin.
Circuit Interrupter
to be used for
plugs and
27. Check
supported.
28. Pay attention that the wheel continues to
rotate after the tool is switched off.
29. Do not use the tool on any materials
containing asbestos.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
(GFCI)
the tool.
three-pole
5
that the workpiece
･
volts
･
amperes
･
hertz
･
alternating current
･
rated speed
･
revolutions or reciprocation per minute
is properly
USD103-1