Velleman CAMCOLVC1 Notice D'emploi page 5

• Note that the controls are located on the back of the device, so easy
access should be anticipated.
• The camera can be powered by batteries (not incl.) or via the included
mains adaptor. When using the adaptor, a mains outlet must be foreseen at
max. 1m distance from the camera.
• Mount the camera on the wall or ceiling. Use either the wall mounting hooks
[I] or the included mounting bracket.
•
wall mounting: screw 2 screws in the wall, level with 38mm space in
between and a leave a gap of ±4mm between screw head and wall.
Hook the camera over the screws.
•
mounting bracket: use the wall plate to determine the location of the
screws and screw the wall plate to the wall. Attach the mounting bracket
to the camera using the mounting bracket thread [H]. Screw the
camera on the wall plate.
• The camera can be powered by batteries (not incl.) or via the included
mains adaptor.
• To view the camera images in real-time, the included video cable can be
used (length ±1.5m).
7. Configuration/operation
•
Insert batteries in the device (see §8) or plug the connector from the power
adaptor into the power input [F] and plug the adaptor in a mains outlet.
•
Insert an SD memory card (not incl.) into the SD card slot [B] (cut away
corner towards on/off switch [A]).
•
Set the video system (PAL or NTSC) with the dipswitch [10], for NTSC
move it to the left. Use a small object e.g. a tip of a pencil.
•
Set whether the camera should stop or overwrite the memory card
content when the memory card is full. To stop recording when the card is
full, move the dipswitch [11] to the left.
Note: only move the dipswitches while the camera is off.
•
Use the included video cable to connect the video output jack [C] with a
video input of a monitor (not incl.). Switch on the monitor.
•
Switch on the camera by moving the power on/off switch [A] to the ON-
position.
Note: when a new card is inserted, the record LED [3] will blink for a
certain time. Wait until the blinking stops.
•
Press the menu button [1] to enter the camera menu. The menu LED [2]
switches on and menu is shown on the monitor. Refer to the next page
for a menu overview.
•
To navigate through a menu, use the up [4] and down [6] button. Select
a menu item with the + button [8]. To change parameter values use the
+ [8] or – [9] button. To exit a menu item, use the menu button [1].
14/01/2009
CAMCOLVC1
5
®
Components nv
©Velleman