Safety Warnings - Festool C 18 Li Notice D'utilisation D'origine

English
Contents
1 Symbols..................................................... 12

2 Safety warnings.........................................12

3 Intended use..............................................13
4 Technical data........................................... 13
5 Functional description.............................. 14
6 Commissioning..........................................14
7 Battery pack.............................................. 14
8 Settings......................................................15
9 Tool holder, attachments..........................15
10 Working with the machine........................ 15
11 Service and maintenance..........................16
12 Environment.............................................. 16
13 General information.................................. 16
1 Symbols
Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear protective goggles.
Wear a dust mask.
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tip or advice
Handling instruction
Inserting the battery pack
Removing the battery pack
12
2 Safety warnings
2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2 Machine-specific safety notices
Hold the power tool by insulated gripping
-
surfaces, when performing an operation
where the cutting accessory or fasteners
may contact hidden wiring. Cutting acces­
sory contacting a "live" wire may make ex­
posed metal parts of the power tool "live"
and could give the operator an electric
shock.
Safety instructions when using long drill bits
a) Never operate at higher speed than the
-
maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if al­
lowed to rotate freely without contacting
the workpiece, resulting in personal injury.
b) Always start drilling at low speed and
-
with the bit tip in contact with the work­
piece. At higher speeds, the bit is likely to
bend if allowed to rotate freely without con­
tacting the workpiece, resulting in personal
injury.
c) Apply pressure only in direct line with
-
the bit and do not apply excessive pres­
sure. Bits can bend causing breakage or
loss of control, resulting in personal injury.
2.3 Further safety instructions
- Use appropriate detection devices to look
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
-