Cd-Player - Sony Game sync LBT-XG700 Mode D'emploi

Speakers
"PROTECT" and "PUSH POWER" appear
alternately.
• A strong signal was input. Press ?/1 to turn off
the power, leave the system turned off for a
while, then press ?/1 again to turn on the power.
• Check the speaker cables in case "PROTECT"
and "PUSH POWER" appear alternately again
after you turn the system on.
Sound comes from one channel or unbalanced
left and right volume.
• Check the speaker connection and speaker
placement.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty (see "Notes on CDs" on page
25).
• The CD is inserted label side down.
• The CD is moist.
Play does not start from the first track.
• The player is in program or shuffle mode. Press
PLAY MODE repeatedly until "PROGRAM,"
"ALL DISCS SHUFFLE," or "1 DISC
SHUFFLE" disappears.
Tape Deck
The tape does not record.
• The tab has been removed from the cassette (see
"To save a tape permanently" on page 25).
• The tape has reeled to the end.
The tape does not record nor play, or there is a
decrease in sound level.
• The heads are dirty (see "Cleaning the tape
heads" on page 25).
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 25).
The tape does not erase completely.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 25).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
"Cleaning the tape heads" on page 25).
Noise increases or the high frequencies are erased.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 25).
Tuner
Severe hum or noise ("TUNED" or "STEREO"
flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect the
external antenna.
A stereo FM program cannot be received in stereo.
• Press STEREO/MONO so that "STEREO"
disappears.
If other troubles not described above
occur, reset the system as follows:
1
Press c/CLOCK SET, ENTER/NEXT and
?/1 at the same time.
2
Unplug the power cord.
3
Plug the power cord back in.
4
Press ?/1 to turn on the power.
The unit is reset to factory settings. All the
settings you made are cleared.
27 GB