GE Profile XPIOX4SWBB Manuel Du Propriétaire page 12

Side Tank Accessory
6. Continued.
Side tank clip
7. L ift the side tank reservoir from the base, unscrew the cap and fill side tank with water. Replace cap after side tank
reservoir is full.
8. C arefully flip over Opal Side Tank's reservoir and place in the base. Water should start flowing into the Opal Nugget
Ice Maker and bubbles in the Opal Side Tank will appear periodically during the time water is flowing to the ice maker.
9. Fill Opal Nugget Ice Maker's reservoir (if desired).
10. Plug in Opal Nugget Ice Maker, and begin making ice.
Use and Care
Cleaning the Side Tank
■ R emove and drain the Side Tank.
■ I f there is residual water in Opal Side Tank base unit, flip
Opal Side Tank's base to drain.
■ R emove and wash Opal Side Tank's cap and valve with
dish soap and warm water as needed. Ensure the cap is
clean after removing and re-installing by hand.
Side Tank Troubleshooting
If water does not flow from the Side Tank to the Opal Ice
Maker:
12
Side tank
clip area
Bottom view
■ Only remove drain tubes while near a sink or bucket, as
removing drain tubes from Opal or Opal Side Tank will
drain any water in either unit.
Proper Installation and Location
The side tank should be installed flush to the front of the
Opal Nugget Ice maker. Opal Side Tank needs to sit on the
same level surface as your Opal Nugget Ice Maker. Do not
elevate Opal Side Tank, or your Opal may overflow.
There may be bubbles in the tube connecting the side tank
to the Opal if the tube is not lying flat. Try adjusting the
tube to allow the water to flow. Once water starts flowing it
typically will not need further adjusting.
Side tank clip
Bottom view
49-9000063 Rev. 1