Factory Reset; Select Language - LENCO MC-148 DAB+ Mode D'emploi

DAB+ OPERATION
DRC (DYNAMIC RANGE CONTROL)
This causes the radio to reduce the dynamic range of the audio signal.
The purpose of this is to adapt the dynamic range of the audio signal
to listening in a noisy environment.
NOTE: This is not available on some DAB+ stations.
1. Press the STOP/MENU button in DAB+ mode, and use either
on the unit,
PAUSE button on the main unit or ENTER button on the remote .
2. Choose between DRC off, DRC high and DRC low using either
on the unit,
/
3. Press the ENTER or PLAY/PAUSE button to save the setting.

FACTORY RESET

Follow the below steps to restore to factory settings.
1. Press the STOP/MENU button. Use
buttons on the remote control to find
button.
2: When you see
3. Select <Yes> using
process.
NOTE: Once the reset has been taken place, you will lose all the
stored presets both on DAB+ and FM mode, and the internal DAB+
registry.

SELECT LANGUAGE

Follow the below steps to select the language of the system.
1. Press the STOP/MENU button.
2. Use buttons on the remote control to find <System>, press
/
ENTER button.
3. When you see <Language>, press ENTER button.
4. Use buttons to select one of the system languages, press
/
ENTER button to confirm selection.
on the remote to find <DRC>. Press the PLAY/
/
on the remote control.
/
< Factory Reset >, press ENTER button.
/
buttons, then press ENTER to reset
/
buttons on the unit or
< System > , press ENTER
11
/
/