Midea MRF27I6BST Manuel D'utilisation page 16

Using the Water Pitcher
To make sure the water pitcher's AutoFill function works properly, place the pitcher correctly on the
holder and close the door. After a while, the water in the pitcher will automatically fill to the preset
level.
Cooled purified water is available in the water pitcher. You can put tea or fruit in the filter and enjoy a
variety of fruity water you like.
To get cold brew water
1. Grasp the handle slot on the lid and pull up to open the lid.
2. Twist the filter element and remove it from the lid.
3. Place the tea or fruit in the filter element according to your taste.
4. Make sure the water pitcher is in the pitcher holder.
5. Close the door. The water pitcher will start filling with cooled water after a short time.
EN
Notes:
After the refrigerator is powered on again, wait 3 minutes for the automatic filling function of
>
the pitcher to work.
If there is too much moisture on the front of the water pitcher (specially marked area), the
>
pitcher may not be fully filled. Please remove moisture and try again.
If the water pitcher fails to fill within a certain time, the automatic water filling function will
>
stop supplying water to the pitcher. If this happens, check that the water pipes are properly
connected. Take out and reinsert the water pitcher and try again.
Tips:
We recommend drinking fruit soaked water within 24 hours. After this time, the water may
>
spoil.
The water pitcher must be washed after drinking the soaked water. If the water pitcher is not
>
used for a long time, it also needs to be cleaned.
To prevent the water pitcher from pouring or leaking, make sure the pitcher fits on the pitcher
>
holder.
To prevent the water pitcher from overflowing or leaking, make sure the lid is properly inserted.
>
1
2
16