Tecsis S2350 Instructions De Service page 29

8. Parameter/Programming
Password
Password protection can be activated in programming mode. The pressure switch is
„
protected from unauthorised setting modifications.
If you forget the password, assistance can be obtained from tecsis. The serial number
„
of the pressure switch will be needed in this case (on the name plate).
Switching points and Reset point
The switching point(s) can also be programmed without the presence of pressure. The
„
decimal points are specified in the factory in accordance with the measuring / adjusting
range and the associated accuracy.
The switching function (normally closed / normally open contact) is defined individually
„
for each switching point. Each switch output is programmed to switch to P potential or
N potential. (Exception Model S2420 = P potential)
Betriebsanleitung / Operating manual / Instructions de service / Instrucciones de uso
Status-LED switching output
1 2
GB
29