Starting Operation - Tecsis S2350 Instructions De Service

6. Packaging / 7. Starting, operation
6. Packaging
Has everything been supplied?
Check the scope of supply:
Completely assembled pressure switches
„
Ordered accessories
„
Inspect the pressure switch for possible damage during transportation. Should there be
„
any obvious damage, inform the transport company and tecsis without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.
7. Starting, operation
Required tools: wrench (flats 27)
Diaphragm test for your safety
It is necessary that before starting the pressure switch you test the diaphragm visual, as this is
a safety-relevant component.
Pay attention to any liquid leaking out, for this points to a diaphragm damage.
„
!
Use the pressure switch only if the diaphragm is undamaged.
„
Use the pressure switch only if it is in a faultless condition as far as the safety-
„
Warning
relevant features are concerned.
24 Betriebsanleitung / Operating manual / Instructions de service / Instrucciones de uso
GB