Wiring Information - Ranger Dst2420 Manuel D'installation Et D'utilisation

Wiring Information

The Balancer comes with a Power Cord with three exposed wires. The three exposed wires need to
be connected to a 230 VAC or 115 VAC Plug, which is then connected to an appropriate power outlet.
DANGER
DANGER
The Balancer is delivered with a Power Cord but
The colors of the three exposed wires exiting the back of the Balancer are Brown, Blue, and
Green/Yellow, the European color code. Note that the Green/Yellow wire can sometimes appear
almost all Green, with very little yellow.
⚠
DANGER
If using the unit in the United States, the wiring color codes delivered with the Balancer are:
• Brown: Live
• Blue: Live
• Green/Yellow: Ground
If using this unit in a European country, the wiring color codes delivered with the Balancer are:
• Brown: Live
• Blue: Neutral
• Green/Yellow: Ground
Information about color code conventions in other regions is available online. Make sure the Electrician
installs the plug in accordance with all applicable local electrical codes.
DST2420 Wheel Balancer
All electrical work, such as attaching a Plug to a Power Cord,
a licensed electrician
Damage to the unit caused by improper electrical installation voids your warranty.
NEVER connect the balancer's ground wire (green/yellow) to a
neutral wire!
The plug and wiring may vary based on local electrical codes and practices.
in accordance with all applicable local electrical codes.
not
a Plug. The Electrician must supply one.
45
must be done by
P/N 5900233 — Rev. F — August 2025