Ranger DST2420 Manuel D'installation Et D'utilisation page 26

• Distance, Width, and Diameter diagrams. Located just above the Plus and Minus buttons,
they are visual representations of how the Wheel is measured, to get the necessary information:
o Distance. Distance from the side of the Balancer to the Inner Edge of the Wheel.
o Width. Width of the Wheel from the Inner Edge to the Outer Edge.
o Diameter. Diameter of the Wheel at the Rim.
See
About Measurements
• Plus, and Minus buttons. Press to increase the value (Plus button) or lower the value (Minus
button). One set for each column: Distance, Width, and Diameter.
• F button. Press to switch between Balancing Modes.
• R button. Used with Stop button to toggle Auto Hood Start.
• Start button. Starts the Wheel spinning, if the Hood is down. By default, lowering the Hood
starts the Wheel spinning. To disable this, press Stop and then press the R button. Press Stop and
R again to re-enable.
• Stop button. Stops the Wheel from spinning.
⚠
WARNING
• <5g button. By default, the Balancer shows values for Weight needed rounded to .25 ounce
(7 grams). To see Weight values at a more granular level, press and hold <5g.
Weight values are shown
For example:
The above is just an
DST2420 Wheel Balancer
for more information.
In an emergency, the fastest way to stop the Wheel and the Shaft is to press the
Stop button and press down on the Brake Pedal.
not
rounded off while pressing and holding <5g.
example
of the more granular values.
26
P/N 5900233 — Rev. F — August 2025