Ranger DST2420 Manuel D'installation Et D'utilisation page 16

Not necessarily to scale. Not all components shown.
9. When the Set Screws are correctly installed, put the large washer and hex head bolt into place on
the end of the Shaft (the Hex Head Bolt Hole) and tighten the hex head bolt.
Switching to the
10.
washers.
They come from the factory in place at the top of the Hood Mount Arm.
11. Switching to the Hood
the Hood Mount Arm.
The Handle in the Hood should be at the front of the Balancer.
12. Replace the two hex bolts and split lock washers just removed and tighten them securely.
13. Test the Hood to make sure it moves back and forth smoothly.
DST2420 Wheel Balancer
of the Hood Mount Arm
top
, put the Rod on one corner of the Hood into position next to the top of
16
, remove the two hex bolts and the split lock
P/N 5900233 — Rev. F — August 2025