Ranger DST2420 Manuel D'installation Et D'utilisation page 39

Switching Inches and Millimeters for Diameter
When entering measurements for a Wheel, you can have the values for Wheel Diameter display in
either Inches or Millimeters. The default is Inches.
To switch from Inches and Millimeters for Wheel Width measurements:
1. Turn the Balancer Off and then back On again using the On/Off Switch.
This sets the Wheel Diameter display setting back to the default, Inches.
2. Specify a Distance value and then a Width value.
3. Press the + or – button under Diameter.
-d- appears on the Inner Window and a value appears in the Outer Window.
The value in the Outer Window does not matter if you are just changing the setting.
4. Press and hold the Stop button, then press the + and – buttons under Diameter.
A beep will sound, then the display will change from Inches to Millimeters.
5. To tell which setting is active, look at the values in the Inner and Outer Windows:
o If the values have decimal points, Inches are active.
o If the values
Note:
Important:
Toggling Auto Hood Start
By default, lowering the Hood starts a balancing session. This is a convenience feature, so you only
have to lower the Hood, not lower the Hood and then press Start.
Important:
Auto Hood Start is a toggle:
disable
• To
sound. The setting has been changed.
enable
• To
sound. The setting has been changed.
How do you know if Auto Hood Start is enabled or disabled? Put the Hood up (if it is down), then lower
the Hood. If a balancing session starts when lowering the Hood, then Auto Hood Start is enabled. If a
balancing session does not start when the Hood is lowered, then Auto Hood Start is disabled.
Note:
DST2420 Wheel Balancer
do not have decimal points, Millimeters are active.
The Inches/Millimeters setting for Wheel Diameter is
It resets to the default, Inches.
It is important to know what measurement system is active when entering
measurements. If the measurement system is not known, a value could be entered in
Inches when the Balancer is set to Millimeters, or vice versa.
If the Hood is up, you cannot start a balancing session. To start a balancing session
when Auto Hood Start is disabled, put the Hood down, then press Start.
Auto Hood Start, if it is enabled, press Stop and then press the R button. A beep will
Auto Hood Start, if it is disabled, press Stop and then press the R button. A beep will
The Auto Hood Start setting, whether enabled or disabled, is saved when you restart the
Balancer.
not
39
saved if you restart the Balancer.
P/N 5900233 — Rev. F — August 2025