Maintenance - Ranger Dst2420 Manuel D'installation Et D'utilisation

Maintenance

Make sure the Balancer is maintained on a regular basis.
DANGER
To maintain your Wheel Balancer:
• Daily: Make sure the unit is clean and dry by cleaning it after each use.
• Weekly: Make sure the Shaft Assembly is correctly oriented with the Shaft Housing and is
securely tightened.
• Monthly: Make sure all Anchor Bolts are tightened and secure.
• Monthly: Check all components to make sure they are in good operating condition. If a
component that is
Troubleshooting
• Every three months: Check the bolts on the components attached to the rear of the unit to
make sure they are tight and secure.
• Yearly: Have an Electrician come out and check the electronic components.
• Yearly: Take the unit out of service, disconnect the Balancer from its power source, then
thoroughly check and clean all components.
⚠
WARNING
DST2420 Wheel Balancer
Disconnect the Balancer from power
and take whatever steps are necessary to make sure the Balancer cannot be
re-energized until Maintenance is over. Because the Balancer uses electricity, you
could be electrocuted or even killed if the unit is powered back on during
Maintenance. If your organization has Lockout/Tagout policies, make sure to
implement them before beginning Maintenance.
not
working correctly, take the unit out of service and refer to
for more information.
Do not operate the Balancer if you find issues; instead, take the unit out of service,
then contact the dealer, visit www.bendpak.com/support/, call BendPak
Ranger at (805) 933-9970, or email support@bendpak.com.
before performing any maintenance
40
P/N 5900233 — Rev. F — August 2025