Genesis GAG645 Manuel D'utilisation page 9

OPErATiOn
SAVe THeSe INSTRuCTIONS
WArninG:
may cause serious personal injury.
WArninG:
WArninG:
extended use. Apply caution when locking tool in "ON" position and maintain a firm grasp on the tool.
SWITCH ACTION:
1. To start the tool, slide the slide switch forward to the (ON) position.
2. for continuous operation, press the front of slide switch downward to lock it on.
3. To stop the tool, press downward on the rear of slide switch, the switch will return to the
"Off posistion.
INSTALLING THE AUXILLARY HANDLE:
WArninG:
performing any work on the tool.
your grinder is equipped with a two position auxillary handle; it can be mounted on either the
left, or right side of the die cast gear housing. Generally, a right handed operator will grip the
body of the grinder with their right hand and grip auxillary handle, mounted to the left side of
the gear housing, with their left hand. The opposite gripping and auxillary handle placement
is generally used by a left handed operator. Occasionally, auxillary handle placement needs
to be changed to accommodate the requirements or restrictions of the operation being
performed.
To mount the auxillary handle to the grinder, simply securely screw the handle into the
threaded hole on the left, or right side of the die cast gear housing.
INSTALLING OR REMOVING WHEEL GUARD:
WArninG:
Always be sure that the tool is switched off and unplugged before
performing any work on the tool.
1. To mount the wheel guard, loosen the clamp lever on wheel guard's band.
2. Align the small protrusion on the inside of the wheel guard band with the notch on the grinders
bearing cap shoulder, then slip the guard's band onto the shoulder of the bearing cap.
3. Slightly rotate the guard so that it is positioned as shown in the figure on the last page of this manual.
4. Tighten the clamp lever securely.
5. To remove the guard, follow the installation procedure in reverse.
WArninG:
wheel, or abrasive mop disc, the wheel guard must be fitted on the tool so that the closed side of the
guard always points towards the operator.
INSTALLING OR REMOVING DEPRESSED CENTER GRINDING WHEELS:
WArninG:
adding accessories, or checking a function on the tool.
1. Mount the inner flange with the machined "flats" side down onto the spindle. Slowly rotate the inner
flange until it engages the corresponding matching machined "flats" on the spindle shaft.
MISuSe or failure to follow the safety rules stated in this instruction manual
Before plugging in the tool, always check to see that the tool is switched off.
The switch can be locked in "ON" position for ease of operator comfort during
Always be sure that the tool is switched off and unplugged before
When using a depressed center grinding wheel, flex wheel, wire wheel, cut-off
Always be sure that the tool is switched off and unplugged before adjusting,
10