Extension Cords - Genesis GAG645 Manuel D'utilisation

your mouth or eyes, or lay on your skin may promote absorption of
harmful material. Always use properly fitting niOSH/OSHA approved
respiratory protection appropriate for dust exposure, and wash
exposed areas with soap and water.

EXTEnSiOn COrDS

Grounded tools require a three wire extension cord. Double insulated tools can use
either a two or three wire extension cord. As the distance from the power supply outlet
increases, you must use a heavier gauge extension cord. using extension cords with
inadequately sized wire causes a serious drop in voltage, resulting in loss of power
and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for
example: a 14 gauge cord can carry a higher current than a 16 gauge cord. When using
more than one extension cord to make up the total length, be sure each cord contains
at least the minimum wire size required. If you are using one extension cord for more
than one tool, add the nameplate amperes and use the sum to determine the required
minimum wire size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix
"W-A" ("W" in Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified person
before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4 18
3.5–5.0 18
5.1 –7.0 18
7.1–12.0 18
12.1–16.0 14
16.1–20.0
12
SPECiFiC SAFETY rULES FOr AnGLE GrinDErS
DO nOT let comfort or familiarity with your angle grinder (gained from repeated use)
replace strict adherence to angle grinder safety rules. if you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
50 Feet 75 Feet
18 18
18 18
18 16
16 14
14 12
12 10
10 8
100 Feet 150 Feet
18 16
16 14
14 12
12 12
10 8
10 8
8 6
200 Feet
16
14
12
10
8
6
6