Genesis GAG645 Manuel D'utilisation page 10

2. Slide the wheel, crown side down and depressed side up, over the spindle shaft and over the
raised shoulder on the inner flange.
3. Screw the outer flange onto the spindle with the shouldered side down.
4. firmly depress the spindle lock so the spindle cannot revolve; then use the lock nut wrench,
turning it clockwise, to securely tighten the outer flange.
5. To remove the wheel, follow the installation procedure in reverse.
WArninG:
flange. failure to do so will cause the grinding wheel to crack when tightening the clamp nut. This
could result in serious personal injury because of loose particles breaking off and being thrown from
the grinder. Never use a grinding wheel with a mounting hole larger than 5/8". Do not overtighten.
WArninG:
on the tool. The wheel can shatter during use and the guard helps reduce the chances of personal
injury.
INSTALLING OR REMOVING AN ABRASIVE DISC:
WArninG:
adjusting, adding accessories, or checking a function on the tool.
1. Mount the rubber backing pad onto the spindle.
2. Place abrasive disc onto the spindle, then fit the disc onto rubber pad and begin to screw the
outer flange onto the spindle.
3. firmly depress the spindle lock so that the spindle cannot rotate, then use the lock nut wrench
and securely tighten clockwise.
4. To remove the disc, follow the installation procedure in reverse.
GRINDING AND SANDING OPERATION:
WArninG:
pressure. forcing and excessive pressure could cause dangerous wheel breakage.
ALWAyS replace the wheel if the tool is dropped while grinding.
NeVeR bang or hit the grinding wheel or disc onto the work.
Avoid bouncing and snagging the wheel, especially when working on corners, sharp
edges, etc. This can case loss of control and kickback.
NeVeR use the tool with wood carving blades or other saw blades. It is only designed for
grinding, sanding, or wire brushing.
WArninG:
comes to a complete stop before putting the tool down.
ALWAyS select and use grinding wheels that are recommended for the material to be
ground. ensure that the minimum operating speed of any accessory wheel selected
4-1/2" 6-Amp Angle Grinder
Operator's Manual
Always install grinding wheel with the depressed center against the disc
Always use the supplied guard when a depressed center grinding wheel is
Always be sure that the tool is switched off and unplugged before
Never force the tool; the weight of the tool applies adequate
After operation, always switch off the tool and wait until the wheel
GAG645