Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
area to improve suction. Repeat this process across the
entire stained area.
10. Repeat the spray solution, scrubbing and vacuuming
process as necessary.
11. Once area is cleaned, allow the area to completely dry
and check treated area for any remaining staining.
nOTE: Treated area may still appear stained while wet.
Please allow treated area 24 hours to dry completely. If
still stained, repeat stain cleaning process.
Fig. F
7
19
12
Emptying and Cleaning the Collection
(Fig. G-I)
Tank
There are two methods of cleaning the collection tank
quick empty method for liquid only waste and a thorough
clean out method for solid and liquid waste.
Removing Collection Tank (Fig. G)
WARNING:
in the collection tank
main body
3
.
1. When fluid reaches the max. fill line
the vacuum OFF.
2. Slide the collection tank release button
main handle
2
.
3. Pull the collection tank
the main body
3
.
Fig. G
9
28
6
14
DO NOT try to empty waste
8
when still installed on the
28
(250 ml)), turn
9
toward the
straight down and away from
8
Liquid Only Waste (Fig. H)
1. Remove collection tank
2. Place collection tank
3. Pull the liquid plug
drain liquid contents quickly.
4. Once drained, reinstall liquid plug
5. Install collection tank
firmly into position.and resume cleaning.
6. If cleaning task is complete, follow Maintenance
instructions for cleaning and storage.
Fig. H
10
Solid and Liquid Waste (Fig. I)
WARNING:
8
, a
in the collection tank
main body
1. When fluid reaches the max. fill line
the vacuum OFF.
nOTE: It is best to empty the collection tank
the fluid reaches the max. fill line
2. Remove collection tank
3. Place collection tank
4. While holding the bottom half of the collection tank,
unlock the latch
5. Open the collection tank
an appropriate disposal area.
6. Rinse the collection tank
leftover debris.
2
7. Close the collection tank
ensuring the collection tank
8. Remove the foam filter
and allow to dry. See Cleaning Collection Tank for
instructioins. Once dry and clean, install into place.
nOTE: The foam filter is re-usable, do not confuse
it with a disposable filter, and do not throw it away
3
when the product is emptied. We recommend that you
replace the foam filter every 6–9 months depending on
frequency of use.
nOTE: Check to see if the pre-filter
8
and debris. Clean if needed. See Cleaning Collection
Tank for instructioins.
9. Install collection tank
firmly into position.and resume cleaning.
8
from main body
8
over an appropriate disposal area.
10
and tilt the collection tank
10
.
8
onto main body
DO NOT try to empty waste
8
when still installed on the
3
.
28
(250 ml), turn
28
(250 ml).
8
from main body
8
over an appropriate disposal area.
11
at the front of the collection tank
8
and pour the contents into
8
with water to remove
8
and lock the latch
8
is properly sealed.
15
and rinse clean with water
16
is free of water
8
onto main body
3
.
8
to
3
until it "clicks"
8
28
8
before
3
.
8
.
11
,
3
until it "clicks"
Publicité
Table des Matières
