Connections, Controls And Indicators - LD Systems VIBZ 6 Manuel D'utilisation

CONNECTIONS, CONTROLS AND INDICATORS

29 33
1
2
11
3
4
5
6
7
8
9 9
10
39 38
1
MIC IN CHANNEL 1 / 2
Balanced inputs of the mono channels 1 and 2 with 3-pin XLR sockets for connecting microphones. A 48 V phantom power supply is
available for operating condenser microphones, and it can be switched centrally to the XLR sockets (N° 37). Please set the Gain controller
(N 3) to minimum (left stop) before connecting or disconnecting a microphone; and switch on the phantom power only after connecting the
microphone, or off before disconnecting.
2
LINE IN CHANNEL 1 / 2
Balanced inputs of the mono channels 1 and 2 with 6.3 mm jack to connect a source device with a line level. Please set the Gain controller
(N 3) to minimum (left stop) before connecting or disconnecting jack cables.
3
GAIN CHANNEL 1 / 2
Adjusting the gain of the microphone input from 0 to 50 dB, or the sensitivity of the line input from +15 dBu to -35 dBu. Adjust the Gain
controller so that the peak LED of the corresponding channel only lights up briefly when signal peaks occur. Avoid the permanent lighting of
the peak LED by reducing the input gain or input sensitivity.
4
EQUALIZER HI CHANNEL 1 / 2
Equalizer high band for channels 1 or 2 (12 kHz, +/-15 dB). When turned to the left, levels are lowered, when turned to the right, they are
raised. In the centre position (resting point), the equalizer is inactive.
5
EQUALIZER MID CHANNEL 1 / 2
Equalizer mid band for channels 1 or 2 (2.5 kHz, +/-15 dB). When turned to the left, levels are lowered, when turned to the right, they are
raised. In the centre position (resting point), the equalizer is inactive.
6
36
27
26
11 24 32
12 40
37
35
13
25
30
14
31
15
16 16 28 34
17
36
29 33 27
1
26
2
11 11 24
3
4 12
5
6 13
7
14
8
15
9 9 16 16
10 17
39 38
23
32 22
20 21
18 40
37
35
19
25 30
31
28 34