Controls And Indicators - LD Systems LDMS828 Manuel D'utilisation

CONTROLS AND INDICATORS:

1
SPLITTER / MAIN INPUT LEVEL
Volume control for the signal at the stereo input (MAIN IN LEFT/RIGHT).
2
MIXER / MAIN OUTPUT LEVEL
Volume control for the signal at the stereo output (MAIN OUT LEFT/RIGHT).
3 MAIN LINK
When the MAIN LINK switch is depressed, the signal at the stereo input (MAIN IN LEFT/RIGHT) is sent to
the stereo output (MAIN OUT LEFT/RIGHT). The result is a mix of signals from the stereo output and mixer
channels 1 - 6, which are connected as mixer channels (Button 8 in channel depressed).
4
INPUT LEVEL
6-segment LED level metre for the signal at the stereo input (MAIN IN LEFT/RIGHT). The red CLIP LED of
the level metre lights up as soon as the level of the signal at the stereo input is 4 dB below the clipping
threshold. Brief flashing of the CLIP LED when peaks occur in the connected signal is not critical. Permanent
illumination of the CLIP LED should be avoided by reducing the volume of the source device and/or the
volume at the MAIN INPUT LEVEL control.
5
OUTPUT LEVEL
6-segment LED level metre for the signal at the stereo output (MAIN OUT LEFT/RIGHT). The red CLIP LED of
the level metre lights up as soon as the level of the signal at the stereo output reaches the clipping threshold.
Brief flashing of the CLIP LED when peaks occur in the connected signal is not critical. Permanent illumina-
tion of the CLIP LED should be avoided by reducing the volume of the source device, channels 1 - 6, and/or
the volume at the MAIN INPUT LEVEL control.
6
LEVEL CH1 - CH6
Channel in SPLITTER mode: Volume control for the signals at the stereo input. The signals are sent to the
individual output of the respective channel (OUTPUT CHANNEL 1 - 6). The signal strength also depends on
the MAIN INPUT LEVEL volume control.
Channel in MIXER mode: Volume control for the signal at the individual input channel 1 - 6. The signal is
switched to the stereo output (MAIN OUT LEFT/RIGHT).
6
4 5
1
3
2