Power Limitation; Home Connect; Setting Up The Home Connect® App; Setting Up Home Connect - Bosch Nit5063Uc Manuel D'utilisation

Discarding changes to the basic settings
Touch ⁠ .
▶
a All changes are discarded and not saved.
8.11 Power limitation
You can use this function to set the total power of the
cooktop.
The cooktop is set at the factory. You can find the
maximum power of the cooktop on the rating plate. You
can use this function to adjust the configuration to the
requirements of each electrical installation.
In order to not exceed this set value, the cooktop
automatically distributes the available power as needed
between the cooking zones that are switched on.
While this function is activated, the output of each cooking
zone may temporarily fall below the nominal value. If a
cooking zone is switched on and the power limit is
reached, the required power level and the maximum
available power level flash on the power level display. The
appliance regulates and selects the highest power level
automatically.
You can find out how to do this in the "Basic settings"
section → Page 14
9 Home Connect® Home Connect®
This appliance is network-capable. Connecting your
Home Connect®
appliance to a mobile device lets you control its functions
via the Home Connect® app, adjust its basic settings and
monitor its operating status.
The Home Connect® services are not available in every
country. The availability of the Home Connect® function
depends on the availability of Home Connect® services in
your country. You can find information on this at:
www.home-connect.com.
The Home Connect® app guides you through the entire
registration process. Follow the instructions in the
Home Connect® app to implement the settings.
Tip: Follow the instructions in the Home Connect® app as
well.
Notes
¡ Also note the safety information in this instruction
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
¡ Operating the appliance on the appliance itself always
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
¡ In networked standby mode, the appliance requires a
maximum of 2 watts.
¡ Cooktops are not designed to be left unattended.
Always monitor the cooking process.
9.1 Setting up the Home Connect® app
Install the Home Connect® app on your mobile device.
1.
Start the Home Connect® app and set up access for
2.
Home Connect®.
The Home Connect® app guides you through the entire
registration process.
9.2 Setting up Home Connect®
Requirements
¡ The appliance is connected to the power supply and is
switched on.
¡ You have a mobile device with a current version of the
iOS or Android operating system, e.g. a smartphone.
¡ The Home Connect® app is installed on your mobile
device.
¡ The mobile device is in the vicinity of the appliance.
¡ The mobile device and the appliance are within range of
your home network's Wi-Fi signal.
Open the Home Connect® app and scan the following
1.
QR code.
Follow the instructions in the Home Connect® app.
2.
9.3 Wi-Fi symbol
The Wi-Fi indicator on the main screen changes according
to the status and quality of the connection and the
availability of the Home Connect® server.
status
Lights up steadily at half
brightness.
Flashes at full brightness.
Lights up steadily at full
brightness.
Flashes.
Switched off.
9.4 Adding or removing a Wi-Fi home
network
The following overview shows how to add or remove a Wi-
Fi home network.
Wi-Fi home network
status
No Wi-Fi home network
stored.
Home Connect® en-us
Description
No network connection
saved.
Network connection is
being established.
Network connection saved
and Wi-Fi active.
Network settings are reset.
Network not active.
Action
To add the Wi-Fi home
network, briefly press ⁠ .
15