Babboe GWA System Manuel D'utilisation page 29

Error
Description Potential causes
code
5 Motor Stall Gate driver malfunction
Battery
Malfunction in the electrical
cell voltage
6 components for voltage
calibration
detection.
data error
No communication between
display and controller or
Communication
9 speed/torque sensor. The TX,
error
MX, MCU or fuse components
might be damaged.
56
Possible source Action
Check plug 2 (see page 73).
Remove the battery, disconnect
plug 2 by untwisting the two
steel rings. Blow out the plug
and connect both plugs again
Motor, Controller
with the arrows facing each
other. Twist the steel rings
back together again and put
the battery back in its original
position.
Controller Replace the controller
Check plugs 1, 2, and 3 (see
page 73) as follows. Remove the
battery, disconnect the plug by
Display, untwisting the two steel rings.
Controller, Blow out the plug and connect
speed/torque both plugs again with the arrows
sensor facing each other. Twist the steel
rings back together again. Put
the battery back in its original
position.
For the 09C system (Babboe Max-E) there are additional error codes.
Error
Description Potential causes
code
It is possible that the system
is fine but the rider mistakenly
Pedal signal/ triggered error 7 by putting feet
torque on the pedals when turning
7
error when on the display. This accident
powered on can be cleared by restarting
the display with the feet off the
pedals.
Temperature Temperature Controller
10
error >90°C or < -20°
Pedal torque
Controller or torque sensor
11 error
malfunction.
during pedaling
Possible source Action
Speed/
Restart the display keeping
Torque sensor,
both feet OFF the pedals.
Controller
Controller Replace the controller
Check plug 1 (see page 73).
Remove the battery, disconnect
plug 1 by untwisting the two
steel rings. Blow out the plug
Controller, and connect both plugs again
torque sensor with the arrows facing each
other. Twist the steel rings
back together again and place
the battery back in its original
position.
57