Basic Settings - Bosch Nit5663Uc Manuel D'utilisation

en-us Operation
8.10 Basic settings
You can configure the basic settings for your appliance to meet your needs.
Basic settings overview
Display Setting
⁠ Panel lock
⁠ Audible signals
⁠ Volume of the audible signals
⁠ Power limitation
This enables you to limit the total power of the
cooktop, if required, due to the circumstances
of your electrical installation. Observe the
regulations of the local electricity providers.
The available settings depend on the maximum
power of the cooktop. You can find more
information on the rating plate. If the function is
switched on and the cooktop has reached the
set power limit, the required and permitted
power level flashes and you cannot select a
higher power level.
⁠ Demo mode
Demonstration mode for the cooktop: When
you switch on the cooktop,
few seconds and the cooking zones do not
heat up.
⁠ Cookware test
You can use this function to test the quality of
the cookware.
→ "Cookware test", Page 20
⁠ Restoring the factory settings
1 Factory setting
To go to the basic settings
Requirement: The cooktop must be switched off.
To switch on the cooktop, touch
1.
Within the next 10 seconds, touch and hold
2.
seconds.
Product information
Customer service directory
Production number
Production number 1
14
Value
for incorrect use are deactivated.
are activated.
The power is increased by 500 W with each level.
...
...
lights up for a
⁠ .
for 4
Display
⁠
1
- Manual.
- Automatic.
- Function switched off.
- The confirmation signal, the fault signal, and the signal
- The fault signal is activated.
- The confirmation signal and the signal for incorrect use
- All signal tones are switched on
- Quiet.
- Moderate. 1
- Loud.
– Switched off. Maximum power of the cooktop
- 1000 W. Lowest power setting.
⁠ . - 1500 W.
- 3000 W.
⁠ . - 3500 W.
- 4000 W.
⁠ . - 4500 W.
- Maximum power of the cooktop.
- Switched off. 1
- Switched on.
- Not suitable.
- Not ideal.
- Suitable.
1
- Individual settings .
- Factory settings.
Product information
Production number 2
a The first four displays provide product information.
Touch to view the individual displays.
Touch to access the basic settings.
3.
a ⁠ and light up as a presetting.
Touch repeatedly until the desired setting
4.
appears.
Select the required setting in the settings area.
5.
Touch and hold
6.
a The settings are saved.
1
.
1 .
Display
for 4 seconds.