Installation; Select The Menu Language; Store Tv Channels - Philips 51PP9200D/37 Manuel De L'utilisateur

Installation

Settings
Installation 4
Language
Autoprogram
Weak channel installation
Software upgrade
Press the cursor right to select your menu language.
Television installation
Installation mode
Antenna
Cable
Previous Next
Television installation
You can now start automatic installation. This procedure
can take more than half an hour.
Previous Start
Tips:
• When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming.
• When interrupted, the updated channel information is retained as well as the old channel information that were not updated.
• Background autoprogramming occurs only when the TV is turned on.
• Channel information of an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies and update information.
• Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that
channel. (See Installation menu, Weak channel installation, p. 9.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
Language 3
English
Francais
Espanol
Please select your
installation mode.

Select the menu language

&
Press the button on the remote control.
MENU
é
Use the cursor down button to select
"
Use the cursor right button to enter the Installation menu.
' Select and enter the list of available languages with the cursor
Language
right button.
( Select your language with the cursor up/down buttons and press
confirm your selection.
§ Proceed with the Installation menu.
Store the TV channels
& Select in the Installation menu.
Autoprogram
é Use the cursor right button to enter the Autoprogram menu.
" Press the .
OK
' Select or
Cable Antenna
When is selected, the TV will detect antenna signals and will
Antenna
search for antenna TV (NTSC and ATSC) channels available in your local
area.
When Cable is selected, the TV will detect cable company supplied signals
and will search for cable TV (NTSC, ATSC, QAM modulated) channels
available in your area.
Make sure you complete registration with your cable TV provider and
connection of equipment.
( Press the green button "
Note: All channels must be unlocked in order to autoprogram. If requested, enter
your PIN code to unlock all channels. See section on Menu preferences under
Settings, TV menu.
§
Press the green button "
The menu screen disappears and the progress of autoprogramming is
displayed. The progress bar indicates the number of analog and digital TV
channels found.
When Autoprogramming is complete, a message appears confirming the
completion. Press the red button "Finish" and the screen returns to the
Installation menu.
Installation in the Settings menu.
in the Installation mode.
on the remote control.
Next"
Start" to start autoprogramming.
to
OK
7