Christopeit Sport AL 2 Notice De Montage Et D'utilisation page 19

Step 3:
Attach the front post (12) at main frame (1).
1. Slide the handlebar support cover (11) onto the handlebar support (12).
2. Hold the handlebar support (12) with the computer cable (3) against the
main frame holder. Connect the plug for the computer cable (3) coming
out of the bottom of the handlebar support (12) of the computer with the
matching plug for the motor cable (16) coming out of the main frame
(1).
(Note: The computer cable harness (3) projecting from the support (3)
must not slide into the tube, as it is required for later steps of installation.)
3. Place the handlebar support (12) in the locator provided for it in the
main frame (1). Ensure that the cable connections made in step 3 are
not squashed. When putting the steering tube in place, push the former
slowly down into the locator in the main frame. Screw the handlebar
support (12) onto the base frame (1) with the screws (14), spring washers
(15) and washers (13).
4. Push the handlebar support cover (11) into right position to cover up
the screw connection point.
Step 4:
Attach the saddle (34) and saddle slide (33) at saddle support (29)
and the saddle support (29) at main frame (1).
1. Push the saddle (34) with saddle bracket into the saddle slide (33) and
tight it up in desired position.
2. Place the saddle slide (33) into the holder of saddle support (29), set it
at the desired horizontally position and screw it onto the saddle support
(29) by fixing piece (6) washer (32) and star grip nut (31).
3. Push the saddle support tube (29) into the matching locator in the main
frame (1), set it at the desired position and lock it by inserting the bolt
with the quick release (30) in place and doing it up tight.
(Note: To screw in the rapid-action lock (30), the threaded hole in the
main frame (1) and one of the holes in the saddle support (29) must be
aligned. Furthermore, ensure that the saddle support (29) is not pulled
out of the main frame beyond the marked maximum Position. The setting
of the saddle post can be adjusted as desired later. For this, the rapid
action catch (30) must be loosened by only a few revolutions, the cap
of the lock must be pulled away and the saddle adjusted. Then secure
the new setting by tightening the rapid action catch.) Furthermore, you
must ensure when setting this desired position that the seat pillar is not
pulled out of the main frame further than the highest setting position,
which is marked. Attention: Ensure before every exercising that the
saddle is tighten firmly.
19