Leuze electronic DCR 85 Manuel D'utilisation Original page 27

Command-Data
Format: (XXX)YYY
• XXX: register number in ASCII hex
• YYY: setting value in ASCII hex
Tab. 8.2: Decoding – Common Properties
Common Proper-
ties
Tab. 8.3: Decoding – 1D codes
Code
Code Properties
Interleaved 2 of 5
Interleaved 2 of 5
Interleaved 2 of 5
Interleaved 2 of 5
Interleaved 2 of 5
Code 32
Code 39
Code 39
Code 39
Leuze electronic
Parameter Settings
Maximum labels to decode
Ignore duplicate codes (ms)
Parameter Settings
1D barcode aggressiveness
Most aggressive
Less aggressive
Least aggressive
Settings of register C9 are bitwise OR-connected.
• The length (number of digits) is always even and can be represented by an inte-
ger value without using bit 0.
• Bit 0 is used to enable/disable Small Quiet Zone (SMZ)
Decoding
enable
disable
Longueur
Small Quiet Zone (SMZ)
enable
disable
Checksum Checking
disable
enable
Enable and strip from output
Decoding
disable
enable Code 39 but not Code 32
enable Code 32 but not Code 39
enable Code 39 and Code 32
Checksum Checking
disable
enable
Enable and strip from output
Full ASCII Symbology
disable
enable
Command-Data
(34)1 ... 10
(159)0 ... 7FFFFFF
Command-Data
(13)0
(13)1
(13)2
(6E)1
(6E)0
(C9)0 ... 64
(C9)1
(C9)0
(71)0
(71)1
(71)2
(6B)0
(6B)1
(6B)2
(6B)3
(70)0
(70)1
(70)3
(49)0
(49)1
DCR 85
Instructions en ligne
27