Publicité
Keep any one of spoke on
the position of 12 o'clock,
Step 3
press
Anticlockwise rotate wheel
by hand slowly, until the
right SP1 LED lit up full,
add the adhesive weight
Step 4
(to stick the weights on
position of 12 o'clock or 9
o'clock depends SLC=On
or Off)
Anticlockwise rotate wheel
by hand slowly, until the
outside SP1 lit right SP2
LED lit up full, add the
Step 5
adhesive weight (to stick
the weights on position of
12 o'clock or 9 o'clock
depends SLC=On or Off)
Put down safe guard and
Step 6
press
stop
Operation completed
5 . Self-calibration of wheel balancer
5.1. Self-calibration of wheel balancer
5.2. Turn on balancer, install a medium size wheel (14"-18")which can use clip-on
weight, set "a b d" value, then
Do the self-calibration whenever you think the balancer is not accurate. The
100g weight must be accurate.
，after spin
- 16 -
comes
＞
comes
＞
comes
＞
comes
＞
Publicité
