Grille Installation - Canarm Cesd100-3 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

CESD100-3

ULTRA QUIET SLIMLINE DESIGN CEILING EXHAUST FAN

ASSEMBLY INSTRUCTIONS CONTINUED

5b. Slide hanger bar into the channel on the housing. Hold housing in place so

that the housing contacts the bottom of stud. Screw housing to stud

through hole A and hole B on the same side. Screw the hanger bar onto

the stud through its hole.

Screw hanger bar to housing with screw A.

The minimum installation distance between studs is 13 3/8" (340mm)

Install round ductwork.

Connect the round ductwork (not included) to the damper/duct connector, and

run the ductwork to a roof or wall cap (not included).

Using tape (not included), secure all the ductwork connections so that they are

air tight. The ducting from this fan to the outside of the building has a strong

effect on the air flow, noise and energy use of the fan. Use the shortest,

straightest duct routing possible for best performance, and avoid installing the

fan with smaller ducts than recommended. Insulation around the ducts can

reduce energy loss and inhibit mold growth. Fans installed with existing ducts

may not achieve their rated air flow.

ELECTRICAL WIRING CONNECTION

Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the

wiring plate. Refer to the wiring diagram, and connect the wires as shown.

SWITCH I

SWITCH II